RFx7050 A Modules

From GEW MediaWiki
Jump to: navigation, search


Item Number Serial Number Failure Date Fault Report Note Location Date Shipped Date Returned Timestamp
1 N10010249 Receiver does not get LO1 lock and reports LO PLL voltage out of range. Out of CT ICASA landrover. SS100125-03.
2 N10010252 Receiver does not get LO1 & LO2 lock and reports LO PLL voltage out of range. Out of CT ICASA landrover. SS100125-04
3 N10010248 No IF output. Out of SS100125-08
4 N07112020 apple Receiver does not get LO1 & LO2 lock and reports LO PLL voltage out of range. HF ANT SMA connector also broken off. Out of Mike's test rack.(BER)
5 N08050147 2013-02-19 (1)The fault with this receiver is that the IF has a lot of phase noise for V/UHF signals (2)Receiver need GEW mod to run up to 3.6 GHz (3)There is a lot of phase noise on the IF signal from the receiver module when applying a V/UHF signal. See attached screenshot, Channel one is shown for reference, Channel two is the faulty.(4)LO1 lock failure.Also need to check IF out & 10Mhz ref. (5)Back from repair. DC QA Sky-i
6 N10090548 Lost lock during field testing SS100928-01
7 N08050142 Receiver need GEW mod to run up to 3.6 GHz
8 N08050143 23/01/2017 (1)Receiver need GEW mod to run up to 3.6 GHz. Receiver has a very high amplitude roll-off around 3 GHz. (2)Front panel LD LED stays on and the receivers fail to get LO lock. Fault confirmed in EQS bite tree and ATP software 1v11. (3)SMA connectors broken. From qualification 7050c. (4)Receiver does not get LO1 PLL lock. Out of SS080819-05 (25/01/2017) Jean Office 17:03 25/01/2017
9 N10110204 SS111206-03
10 N08090512 Receiver need GEW mod to run up to 3.6 GHz
11 N08090513 2012-12-04 (1)Not clear if mods (3.6GHz) have been installed. Installed in SS100928-08.(2)Receiver fails to get LO lock intermittently.(3)Intermittend LO lock failure - back again with no fault found.(4)LO1 lock failure (5)Card returned after 4th time back for repairs. (6) Allocated for new AC Sky-i's. Sky-i
12 N08090515 Receiver need GEW mod to run up to 3.6 GHz. Receiver does not get LO2 lock and reports LO2 PLL voltage out of range.
13 N08050142 Front panel LD LED stays on and the receivers fail to get LO lock. Fault confirmed in EQS bite tree and ATP software 1v11. Broken RX CTL connector.
14 N11020153 23/01/2017 (1)Receiver does not get LO1 PLL lock. Out of SS080819-05 (25/01/2017) Jean Office 17:06 25/01/2017
15 NCX110435 SS120622-03
16 EY030012 2013-01-25 (1)IF out 20dB low SS120622-04
17 N09010042 Loose fasteners inside module and dry joint on pin 19.
18 N09010046 LO1 PLL does not lock at -10deg.
19 N10010237 Signal amplitude is low across the entire V/UHF frequency range.
20 N10010248 V/UHF signal amplitude was low across entire range. System was shut down over night and powered up the next morning. LD LED on front panel lights up and the module does not get LO lock.
21 N10090567 There is a lot of phase noise on the IF signal from the receive rmodule when applying a V/UHF signal. This unit has already been returned to GEW for the same fault.
22 N10090567 There is a lot of phase noise on the IF signal from the receiver module when applying a V/UHF signal.
23 N10090571 Did not turn on, removed from system and smells burnt.
24 N10090573 10MHz output signal has an amplitude of -62 dBm instead of -1 dBm.
25 N09010043 When supplying a low frequency signal to the HF input the signal is severely attenuated.
26 N09010039 When applying a V/UHF signal to the V/UHF input, the signal is not present on the IF output.
27 11020158 Received one module with serial number 11020158 printed on the sticker, but when the BITE information is read back it is read as 1102158. New Module
28 11020159 All Body Screws loose upon arrival at Peralex. New Module
29 10010240 PLL Lock Error - Bloemfontein Land Rover
30 11020156 Signal at 2.1Mhz drops to -10dBm instead of -5dBm. Fails ATP. It's the receiver (SN: N11020156) that is failing New Module
31 10010244 Signal attenuated at 100kHz. Level -23dBm instead of -5dBm. The IF OUT SMA connector measures 26Ohm instead of 50Ohm between center pin & GND. Possible dry joint in the IF filters.
32 10090548 XTAL PLL1 no Lock Detect (Vietnam Son La RFX) Second Failure. Failed after new 7050 unit was delivered.
33 7110001 Receiver XTAL PLL1 does not lock. Module has been repaired twice previously. Last repair in May 2011
34 EY080246 2012-12-04 (1)Allocated for new AC Sky-i's. (2012-12-04). (2) LO1 lock failure (Failure date:2016/01/14. Back:???) Out of Sky-i SN#SSGS0920-03 GEW PTA 2016/01/15 ??? 16:54 2016/01/14
35 11020155 Receiver XTAL PLL1 does not lock. New Receiver
36 NEY030025 2015/08/25 (1) LO1 lock failure when system warms up.(Back from repairs:2013/03/12). (2) LO1 lock failure (Failure date:2015/08/25. Back:2015/10/29) Out of Block B TDOA Sky-i SN#:SS111206-03 GEW CPT 23/09/2015 2015/10/29 16:04 2015/11/03
37 N10100334 (1)Receiver XTAL PLL1 does not lock.Module 8 months old Removed from SS100928-07. Indonesia Spare(05/05/2015)
38 N10100335 (1)IF Out Failure,Module 8 months old Removed from SS100928-07. Indonesia Spare(05/05/2015)
39 N10010263 2013-03-12 (1)Used in QA Sky-i rack.Spurs throughout the entire band appeared after shock & vibration. (2) Back from repairs(2013/03/12). Sky-i SS111206-01
40 N10090573 Broken IF stage. Removed from ss100928-06 (ICASA Cape Town). Replaced with 11020150 from ss100928-07. (At GEW Pretoria for repairs)
41 N10090547 (1)Amplitude low,Module 8 months old Removed from SS100928-07 Spare (Jean Office)(05/05/2015)
42 N10090579 removed from SS100928-08 (9GHz test receiver) (at GEW Pretoria for repairs). Possible IF output stage fault.
43 N11020174 23/01/2017 (1)New spare module,LO lock failure (2) Working in use. (3)Receiver does not get LO1 PLL lock. Out of SS080819-05 (25/01/2017) Jean Office 17:08 25/01/2017
44 CX120067 new module Designated for TDOA
45 CX120068 2013-01-25 (1)new module (2)Physical damage to front plate and SMA connector. (Designated for TDOA) SS120622-01
46 EY030020 2013-02-28 (1)LO lock failure (2)Returned after repair.(2013/06/10) Original Afrimeasure
47 EY030026 New module Uganda spare
48 N10010256 2013-04-17 (1) LO lock failure. (2)returned after repair(2013/02/11). (3)IF output amplitude is 3dB too high. (4) IF 40dB low, SMA barrel also seems loose and turning. (19/10/2015) returned (29/02/2016). Sky-i SSGS0920-04 20/10/2015 29/02/2016 16:40 03/03/2016
49 N11020148 (1) CTRL connector lock clip broken.(2012/05/25) (2) Integrated into system.(2012/10/23) (3) SS100928-11 (2013-03-05) Spare Jean Office 15:49 2016/06/02
50 EY050781 2016/01/15 (1) New module to replace one sold as uganda spare. Come in with one wedgelock wrong way around.(2012/08/08) (2)Allocated to new Sky-i AC boxes. (2012-12-04) (3) LO lock error. Cannot scan or tune Sky-i (SSGS0920-01) Back to GEW PTA for repair 15/01/2016 ??? 14:17 2016/01/15
51 EY080245 2012-10-22 New module TDOA SS120622-02
52 N10010260 SS111206-05
53 EY080259 (1)New module.Allocated to Afrimeasure. Afrimeasure Spare SS111206-04
54 EY080256 2013-02-12 (1)New module, dedicated to Sky-i Sky-i
55 EY050780 (1)New module, dedicated to Sky-i (2013-02-12) (2) Allocated to TDOA Sky-i (14/10/2016) Operational SSGS0920-01 10:08 2016/10/14
56 EY080253 (1)New module, dedicated to Sky-i (2)IF output is distorted. (2013-04-02) Spare Jean Office 15:54 2016/06/02
57 EY080249 2013-02-12 (1)New module, dedicated to Sky-i Sky-i
58 10090569 2013-02-14 (1)LO1 and LO2 lock failure POLS 7050 GEW PTA for repair
59 10010241 2013-05-02 (1)LO Lock failure. (2)Returned after GEW repair(25/06/2013) ICASA CPT Land Rover
60 10010250 2013-05-02 (1)LO Lock failure. (2)Returned after GEW repair(25/06/2013) ICASA CPT Land Rover
61 EY030016 2013-11-19 (1) Nico repair, IF out faulty when warm, intermittent failure. 5 Signals 7050
62 N11020171 LO2 PLL lock fault(18-08-2015). Out of CT ICASA landrover. SS100928-06. 18-04-2015
63 EY080250 22/10/2015 (1) Cannot tune into VHF. Bite led on RFX stays on. Not even detected in software. (Failed 22/10/2015, returned 13/11/2015) Sky-i SSGS0920-02 22/10/2015 13/11/2015 13:48 19/11/2015
64 09010022 Out of Marketing 1 system (Spare) Jean Office 15:40 2016/06/02
65 09010026 Out of Marketing 1 system (Spare) Jean Office 15:40 2016/06/02
66 09010029 (1) Out of Marketing 1 system (Spare) (2) In 7050C SSGS0724-13 JAWA - KSA 2017/02/17
67 10010239 n/a n/a Stock Unit Dep306 store room(kitchen) "Date Shipped" "Date Returned" 13/01/2017
68 10010238 n/a n/a Stock Unit Dep306 store room(kitchen) "Date Shipped" "Date Returned" 13/01/2017
69 09060618 n/a n/a Stock Unit Dep306 store room(kitchen) "Date Shipped" "Date Returned" 13/01/2017
70 NEY050775 10-12-2016 (1) LO Lock Failure (10-12-2016) (2) Repaired (17-02-2017) Stock Unit - Removed from 7050C SSGS0724-13 Dep306 Store "Date Shipped" "Date Returned" 17/02/2017